Tip While Making Vocal Based Music


Great vocal mixing tip from @Groove3inc:⁠
—————⁠
"When mixing "vocal based" music, it is important to always stat with the vocals. Even if it's not the final sound. It's imperative that everything is build around the vocal so that it's always considered in every other mixing decision. With this method, you'll never be surprised when you add the vocal at the end. It will always work because you've built your mix around it instead of the other way around."⁠
—————⁠
The take away from this is that any important aspects of your mix need to be taken into account from start to finish. ⁠
—————⁠

Comments

Post a Comment

Popular posts from this blog

4 Ways To Make Vocals Clear and In Your Face⁠

Image
4 Ways To Make Vocals Clear and In Your Face⁠ ----------⁠ 1. For a modern sound, the dynamics of vocals need to be consistent. Every word and syllable should be at roughly the same level (allowing for human expression). Use automation to manually level out the vocal before compression.⁠ ----------⁠ 2. Your lead vocals need to be upfront and in-your-face. Applying reverb to the vocal can push the vocal further back in the mix. Instead, use a stereo slapback delay to create a space around the vocal and add some stereo width. Use low feedback (0-10%) and slightly different times on the left and right sides. Delay times between 50-200ms work great.⁠ ----------⁠ 3. Sometimes EQ alone isn’t enough to enhance the top-end. By applying light saturation, you can create new harmonics and add more excitement.⁠ ----------⁠ 4. If you’re recording in a room that’s less than ideal, room resonances can quickly build up. Find these resonances using the boost-and-sweep technique and then remo...
Read more

Kick & Bass Relationship

Image
Getting the kick and bass to work well together is one of the largest challenges of any production, mix or master. In a song where the bass is very powerful and has a long tail, you need a kick sample that compliments the sound rather than conflicting with the sound. ⁣ —————⁣ In this example, the kick sample is very short and punchy. These characteristics help it stay out of the way of the bass. If the kick had a long tail or a heavy low-end the two channels would compete for the same space and the sounds would become a confused mess. If you’re making a track with a long and heavy bass channel, chose a short and punchy kick. If you’ve got a long and heavy kick sample, go for a shorter punchier bass.⁣ —————⁣ Source: https://www.masteringthemix.com/
Read more